Trenchless technologies, method 1: Horizontal directional drilling
August 27, 2017
August 27, 2017
Understanding how and when to use Horizontal Directional Drilling (Part 2 in a series)
In the civil engineering world, finding safer and faster methods to complete the projects with minimum impact on environment and public is the focus for most designers and contractors. I believe Horizontal Directional Drilling (HDD) is one of the most interesting technologies that let us install pipelines, sewer, water mains, power and telecom through steerable and trenchless method where conventional open-cut techniques are not feasible, such as crossing the major highway or a river for utility installation in order to minimize public impact and protect the environment.
So, how does it work? HDD equipment make a horizontal bore hole from one location to another. The process begins with boring a small pilot hole along the desired centerline of a proposed profile under the crossing obstacle (e.g. a highway) with a continuous string of steel drill rod. The position of the drill head can be accurately controlled with devices and sensors that monitor and track the drill head. without directional capabilities, HDD could never have become the primary trenchless construction method for installing underground utilities that it is today. Through small adjustments made by the operator, the drill head can go around trees, under foundations, buried utilities, lakes, or other obstructions.
When the bore head and rod emerge on the opposite side of the crossing, usually a special cutter, called a back reamer, is attached, and pulled back through the pilot hole. The reamer bores out the pilot hole so that the pipe can be pulled through. The pipe is usually pulled through from the side of the crossing opposite the drill rig.
One of the important aspects in the design of the drill-path is creating as large a radius of curvature as possible within the limits of project. The drill-path normally has curvature along its vertical profile. Curvature requirements are dependent on site geometry (crossing length, required depth to provide safe cover, staging site location, etc.). The degree of curvature is also limited by the bending radius of the drill rod and the pipe.
The reaming operation usually consists of using an appropriate tool to open the pilot hole to a slightly larger diameter than the carrier pipe. Normal over-sizing may be from 1.2 to 1.5 times the outside diameter of the carrier pipe. Several reaming passes may be needed for large-diameter pipes which require large boreholes that cannot be created in a single pass. Usually a “drilling mud” such as fluid bentonite clay is injected into the bore while cutting and reaming to stabilize the hole and remove soil cuttings.
A good design practice for HDD pipes in my opinion, should consider, all temporary construction loads and long term service loads. An experienced team should assess pipe properties to ensure smooth installation and operation. Design team must check and determine the competence of pipe in terms of its structural performance.
Here are few extra tips on HDD method:
Interested to learn more about HDD? I recommend reading these articles…